Specifications:
Serial number None located
Pendant control Yes
Swing over bed 36 in
Swing over cross slide 24 in
Center distance 90 in
Bed width 25.5 in
Spindle bore 9.5 in
Chucks No front chuck
20 in 3-jaw with 6 in bore Rear mounted
Spindle speeds 10-350 rpm, 12 steps
Taper attachment Yes, but not bar or taper clamp.
Threading Yes, Inch, Metric, Module, Whitworth
Tailstock Yes
Steady rest No
Coolant Yes
Electrical disconnect Yes
Main motor 18.5 Kw/25 hp.
Dimensions 18 ft W x 6 ft 5 in L x 7 5 in H
Weight 18,000 lbs. estimated
Price: $ 25,000. FOB Houston, TX. Subject to Prior Sale.
Comments: This is an older lathe (probably out of the late 70 es or early 80 es) in no better
than average condition. Everything on it seems to be working. We have replaced a number
of bearings in the carriage and repaired all of the lube lines plus numerous other minor
repairs. This lathe was previously used for drill bit resurfacing (grinding). It has been modified
on the rear with a large drive gear and a gear box to turn the carriage very slowly. A grinding
spindle can be mounted on the carriage in order to perform the same function as when it was last used or
it can again be used as a hollow spindle lathe.
To view more information on the YUASA HOLLOW SPINDLE OIL COUNTRY LATHE, including reviews, brand information, photos, videos, and more,
Fill in the form below to see Seller Info.