Description

NEW SHARP MODEL TMV/MP2 2- AXIS CNC VERTICAL KNEE-TYPE MILL WITH ACURITE
MILLPWR PC BASED CNC CONTROL
SPECIFICATIONS - MILL:
TABLE:
Table Size -------------------------------- 10" x 50"
T-Slots (3) ------------------------------- 0.625" on 2.5" Ctrs.
Weight Capacity (Evenly Distributed Over Center) 900 Lbs.
TRAVELS:
X-Axis (Table) ---------------------------- 29"
Y-Axis (Saddle) --------------------------- 15-1/2"
Z-Axis (Quill) ---------------------------- 4"
Ram In-Out -------------------------------- 19"
Head: Tilt Front to Back ----------------- 20 Degrees
SPINDLE:
Motor 3 HP
Voltage 230V/460V/60 Hz./3 PH
Speed/Range Inf. Var./60-4500 RPM
Spindle Nose Taper R8
Quill Diameter 3.375"
MISCELLANEOUS:
Weight (Net) ------------------------------ 3,200 Lbs.
Depth x Width ----------------------------- 84" x 76"
Overall Height ---------------------------- 93"
CONTROL FEATURES:
10" Flat Panel Color LCD Display
2 - Axis
3 - Axis Readout
Linear Glass Scale Feedback
Servo Amplifiers and DC Servo Motor Axis Drive
Conversational Programming
Trig and Geometry Calculators
Graphical Programming Interface
Tool Table for Diameter and Length Offsets
Manual use of Machine ( without SERVO Motors - DRO Mode )
Automatic and Single Step Operation
PROGRAMMING FEATURES:
Programmable Feed Rates
Rapid Traverse 200 IPM
Inch and MM
2 - Axis Simultaneous Linear Interpolation
Contouring ( Lines, Arcs, Angles and Circles )
Corner Rounding
Repeats ( Looping )
Rotation, Mirror Image
Rectangular ( X, Y ) or Polar ( Angle, Radius )
Coordinate Programming
Subprograms
Program Comments
Canned Cycles
Pockets or Frames - Rectangular, Circular, Irregular, Islands
Drilling - Basic, Peck, Chip Breaker, Boring