Description

Description:

• Load area length: 24\"
• Wash area: 4 ft
• Rinse area: 4 ft
• Blow-off area: 6 ft
• Unload area length: 24\"
• Tank width: 54\"
• Belt Height: 38\"
• Part clearance: 18\"
• Total conveyor length: 18 Feet

Equipped With:

• Heated Wash / Heated Rinse / Blow-Off
• Stainless Steel Tank Construction
• Electric Heat (250 AMP main breaker)

Comments:

• After the initial wash the solution would be stripped by a 20hp regenerative
• blower mounted on top of the machine. It would then go in to the next wet tank
• After that stage, it would enter the blow-off section with
• another 20hp regenerative blower
• New upper walls with large hinged access doors
• New stainless steel insulation skins
• Thoroughly cleaned inside and out
• Brand new stainless-steel roller bed conveyor
• New 1/2hp Marathon Black Max drive motor
• New Grove 100:1 gear box
• New 1” x 1” stainless-steel flat wire conveyor belt
• New stainless-steel sprockets
• New stainless-steel keyed shaft
• New bearings
• New 5.1hp Brinkmann pumps
• New 28Kw heating elements; 2 in the wash and 2 in the rinse
• New stainless-steel Rosedale canister filters
• All new stainless steel plumbing
• New stainless water make-ups with new ASCO valves
• New Keyence FL series level sensors

Scope of Work:

• Work to be completed:
• New 20hp regenerative blower (strip blower / after wash)
• New 20hp regenerative blower (final blow-off / after RP)
• New Losma Darwin 3000 mist collector
• New blowers need to be purchased and installed.
• Panel needs to be built and machine needs to be wired. ALL NEW CONTROLS!!!
• Allen-Bradley MicroLogix 1400 PLC and Automation Direct 10” color touch screen
• Allen-Bradley VFD for the 20HP bottom regenerative blower
• Ball valves to control upper and lower spray on the wash and rinse.
• 6-8 weeks to complete.
• The existing stainless-steel tank was used