Description

Specifications:

• Swing: 60\"
• Stroke: 16\"
• Maximum Traverse Stroke: 21\"
• Work Head Speed: 15, 25, 35, 50 RPM
• Work Head Swivel Adjustment: Up to 90 Degrees
• Max. Including angle which can be ground w/Full 60\" Sw: 60 Degrees
• Cross Adjustment of Work Head (Forward): 16\"
• Cross Adjustment of Work Head (Rear): 14\"
• Wheel Head Cross Travel: 8\"
• Work Head Motor (4-Speed Gear Reduction): 2.5 - 7.5 HP
• Grinding Saddle Motor (1750 RPM, 220/440 V, 3/60): 25 HP
• Hydraulic Pump Motor: 2 HP
• Estimated Net Weight: 24,000 Lbs
• Workhead can be adjust length-wise so that minimum:
• distance from work head spindle flange to forward:
• position of wheel slide: 21\" min to 44\" max.
• Estimated Dimensions (L x W x H): 14\ 6\" x 7\ 3\" x 7\"

Equipped With:

• 60\" \"T\" Slotted Face Plate (3\" Thick)
• 9\" Thru-Hole In Work Head Spindle
• Internal Grinding Spindle ( 16\" Quill Length With Installed
• 11\" Length Quill Extension Total: 28\"
• Adjustable Trip Dogs For Grinding Spindle Saddle Manual/Auto Cycles
• Single Point (Hand Type) Rear Adjustable Table Dresser
• Separate Hydraulic Unit
• Separate Electric Control Panel
• Separate (Baffle Type) Coolant Tank & Pump
• Extra Chuck Jaws ( Soft & Hard )
• Automatic Way Lubrication
• Factory Installed Work head Chuck Guard (Hinge Type For Quick & Easy Access)

Comments:

• Very Good (As Purchased From Running Service At U.S.A. End User Facility)
• This Machine is a Very Rare Extra Large Capacity Horizontal Design
• Hydraulic I.D. Grinder And Shows Low Use On All Square Block Way
• and Way Bearing Surfaces
• Machine Will Be Available For Inspection Under Power At Our Dryden, Michigan
• Warehouse Upon Cycling Which Includes Replacing All Fluids, Filters,
• (Wipers, Screws, Nuts, Bearings If Needed) Coolant Splash Guarding,
• Retractable & Collapsible Traveling Hydraulic Cylinder Guards For Wheel
• Infeeds/Retract
• Machine Will Go Through Our In-House Processing Departments!!!
• Machine Will Be Sanded, Primed, Filled Then Custom Painted With Ppg Ditzler
• High Gloss Acrylic Enamel Paint (7b Gray/Or Color Of Choice)
• Ppg Delstar Slow ( Hot ) Reducer & Ppg Delthane Hardener.
• Machine Paint Will Never Peel, Chip, Crack Or Wear as Our Process Using the
• Highest Quality Materials Will Be Applied to Properly Prepared Surfaces
• of this Extra Large (Extremely Rare) Machine Tool

Video:

• https://youtu.be/6tjr_ErS9lU