Description

Description & Specifications

2L GISHOLT MASTERLINE SADDLE TYPE TURRET LATHE

PRICE: Loaded on Truck, Our Warehouse, York, PA …… $6,950.00

HMC Stock No. 17216
Machine Serial No. 3233-14
Machine Model No. 2L
New Date: 1953

Swing Over Bed: 23"
Swing Over Cross Slide: 19"
Swing Over Carriage Wings: 21"
Bedways to Centerline of Spindle: 11"
Distance Spindle Nose to Turret Face: 10-1/2" Min. to 52" Max.
Distance Spindle Nose to Far Side of Tool Turret: 5-1/2" Min. to 52" Max.
Spindle Nose Type: A1-11 American Standard
Turret Travel: 46-1/2"
(12) Pre-select Spindle Speeds: 12 to 346 RPM via 2 Ranges
Carriage and Saddle Longitudinal Feeds: 0.004" to 0.168" Per Revolution
Cross Feeds are 1/2 of Longitudinal Feeds
Spindle Bore: 4-1/8"

EQUIPPED WITH:
18" 3-Jaw Manual Chuck with 2-Piece Jaws with Hard Reversible Top Jaws
Hole Thru Chuck: 5"
Half Nut Threading on Cross Slide and Saddle
Machine Has a Full Length Lead Screw
Thread Chasing Dials on Carriage and Saddle
Power Rapid Traverse to Carriage, Cross Slide and Saddle
6-1/2" Square Built in Turret Tool Post on Cross Slide
Hard Replaceable Machine Bed Ways in Good Condition
Rear Splash Guard
Chuck Wrench
Spindle Modes: Forward, Reverse and Inching
Machine Headstock is Designed to Accept a Bar Feed – NOT Supplied
Turret Type Adjustable Carriage and Saddle Feed Stops
(3) #5 Morse Taper Long Flange Tool Holder
(1) Single Hole Slide Tool
(1) Short Flange Tool Holder
(1) Long Flange Tool Holder
Plexiglas Swing Up Chuck Guard
Factory Installation, Maintenance & Repair Manual
Coolant Pump with Piping
1-1/2 HP Coolant Pump Motor
Wired for 3 Phase, 60 Hz, 208/220/440 Volts
20 HP Main Motor, 1760 RPM, 50/25 Amps
Wired for 3 Phase, 60 Hz, 220/440 Volts
Presently Wired for 440 Volts

Overall Size: 163" Long x 74" F-B x 73" High on 4" Blocks x 11,000 Lbs.