Description

Reference #:	6401
Machine Type:
Year:	2014
Manufacturer:	Haas
Model:	VS3
Control:	Haas 32 BIT
Condition:	Good
Under Power:	Yes
Code:	M0185

Table:

Table Size: 146" x 40" Maximum Table Load: 10000 Lbs

Travels:

X-Axis Travel: 150" Y-Axis Travel: 50" Z-Axis Travel: 50"

Spindle:

Spindle Speeds - Maximum: 7500 RPM Spindle Taper: CT 50 Taper Main Motor (30 min. / cont.): 30 HP

Tool Changer:

Tool Changer Positions: 30+1 ATC

Rapids:

Rapid Traverse (XY/ Z): 500 /710 IPM

General:

Floor Space Required (L x W): 31 ft x 17 ft

Equipped With:

2-Speed Geared Head 30 Position Side-mount tool changer Remote Jog Handle, Color LCD X-axis linear scales Intuitive Probe System Through Spindle Coolant Rigid Tapping 95-Gallon Coolant Tank Chip Auger Programmable Coolant Nozzles Intuitive Probing, Renishaw Expanded Memory

Comments:

Power On - 10,219 hours Cycle Start - 4186 hours Cutting - 3564 hours Machine cost when new was $404,000 Machine build new was completed in Feb. 2014 - current owner took delivery several months later. Here are irepairs that have been made to this machine: 1. new rails skates - not sure haas says they just wear some times 2. Encoder - has a coolant leak that messed up 3. Counter balance cylinder has very very slow leak we have the guage to fill maybe once a year 4. New spindle not sure why bearing locked up. We had it rebuilt by Setco in Cincinnati 5. One of the chip auger motors is out. We just didnt fix it - it works fine 6. Tool setter is out being repaired by Renishaw. It just did communicate. Probe works great. I want to be completely honest and up front because I would like to be treated the same. Machine has been a great machine and as anyone knows ALL machines has some little issue over all we are selling because only 4% of our work is required to go across this machine We are planning to replace with smaller machines We have the guards we took off. It just easier putting big piece in it. The coolant still stays contained.