Inventory Number: 1851-440
Technical Specifications:
220volt 3phase 60hz
Motor: 3HP
Swing over bed (inches) 11 1/4
Swing over cross slide (inches) 6 3/4
Spindle speeds (number) 12
Spindle speed range (standard) (40 to 1 ratio) rpm 35 to 1200
Spindle speed range - high rpm 53 to 1800
Spindle speed range - super high rpm 88 to 3000
Spindle speed range - low rpm
Spindle reverse Electrical
Spindle nose - standard long taper key drive, dia. of hole thru LO, 1-1/2"
Spindle nose - camlock dia of hole thru D1-3", 1-5/16"
Spindle- number of bearing 2 Taper Roller 1 Ball
Spindle - tape r #5 Morse
Spindle - Size of center #3 Morse
Headstock - base length on bed (inches) 19-3/8
THREAD AND FEED RANGE
Number of thread and feed changes 48
Range of threads per inch, low standard and high speed ranges 3 to 184
Range of threads per inch, super high speed range 6 to 368
Range of feeds = carriage - low, standard and high speed ranges (I.P.R.) .0020 to .1224
Range of feeds - carriage - super high rpm (I.P.R.) .0010 to .0612
Range of feeds - cross slide - low, standard and high speed ranges (I.P.R.) .0005 to .0310
Range of feeds - cross slide - super high rpm (I.P.M.) .0003 to .0155
Leadscrew (Acme) diameter (inches) and threads for inch 1-1/8-8
CARRIAGE AND COMPOUND REST
Cross slide travel (inches) 9
Top slide travel (inches) 2 3/8
Solid tool size (inches) 3/8 x 3/4
Tool hodlers - size of tool shank (inches) and number 3/8 x 7/8 (80)
Carriage bearing on ways (inches) 18-1/4
Width of bridge (inches) 6
TAILSTOCK
Spindle travel (inches) 4 1/2
Spindle diameter (inches) 1 3/4
Spindle - size of center #3 Morse
Tailstock b ody - length on bed (inches) 9 1/4
Tailstock set-over (either side of center) (inches) 1/2
Area of tray top (sq. in.) 50
Overall size: 72" x 30" x 61h
Estimated weight: 1800lbs
Equipped With:
Quick production 5C collet attachment
3 Jaw Chuck
Hardened bed ways
Thread dial
